|
SC-0010
Shift Knob
|
|
Billet aluminum shift knob for ST and MV style controls. Common 3/8"-24 female thread. Available in polished, powdercoated, and anodized finishes.
|
|
|
|
|
SC-0012
Shift Knob - Large
|
|
Large billet aluminum shift knob for ST and MV style controls. 1 3/16" dia. with a female 3/8"-24 thread. Available in polished, powdercoated, and anodized finishes.
|
|
|
|
|
SC-0015
ST Control Shifter
|
|
Billet ST controls are constructed of 6061-T6 aluminum. The handle has 10 degrees of angle to avoid rubbing on the interior. These non-locking controls are most commonly found on jet boats. They are available in polished, powdercoated, and anodized finishes.
|
|
|
|
|
ST-BEZ
Shifter Bezel - ST-Control
|
|
|
DMP billet bezel for ST style controls are constructed from 6061-T6 aluminum. This bezel will fit most common ST jet boat controls. They are available in polished, powdercoated, and anodized finishes.
|
|
|
|
|
SC-0030
Single Position Locking shifter
|
|
Billet locking controls are constructed of 6061-T6 aluminum. The handle has 10 degrees of angle to avoid rubbing on the interior. These single locker controls are designed for jet boat applications where it will only lock into forward position. Available in polished, powdercoated, and anodized finishes.
|
|
|
|
|
SC-0020
3 Position Locking Shifter
|
|
Billet locking controls are constructed of 6061-T6 aluminum. The handle has 10 degrees of angle to avoid rubbing on the interior. These locking controls can be used on jet boats, outboards, and inboard/outboards. Available in polished, powdercoated, and anodized finishes.
|
|
|
|
|
SC-0025
3 Position Locking Shifter w/ Neutral Safety
|
|
Billet 3 position locking controls are constructed of 6061-T6 aluminum. This shifter features a neutral safety switch to prevent starting while engaged in gear. The handle has 10 degrees of angle to avoid rubbing on the interior. These locking controls can be used on jet boats, outboards, and inboard/outboards. Available in polished, powdercoated, and anodized finishes.
|
|
|
|
|
CP-31029
Cable Pivot 33C
|
|
|
|
This cable pivot is used on 33C cables. It has a 1/4" diameter pin that will fit through 9/64" arm.
|
|
|
|
|
CP-31537
Cable Pivot 43C
|
|
|
|
This cable pivot is used on 43C cables. It has a 1/4" diameter pin that will fit through 13/64" arm.
|
|
|
|
|
|
|
|
|
TLM-CC692
43BC Cables (5ft base price)
|
|
|
|
43BC cables are typically used on jet drive applications. The "BC" models use jam nut at one end and a "U" groove at the other end to anchor the cable. These cables have 1/4-28 threads.
|
|
|
|
|
TLM-CC693
43C Cables (5ft base price)
|
|
|
|
43C cables are typically used on jet drive applications. The "C" models use a "U" groove at each end to anchor the cable. These cables have 1/4-28 threads.
|
|
|
|
